Access Cisco Unity voicemail

Below is a list of commands for the Cisco Unity Voicemail system. A complete List of commands is available a PDF attached below, at the bottom of the article.


Log On: Dial x4400, enter your PIN followed by #.

Log Off: Press * and then hang up.

Play Messages: Log on, press 1 to listen to new messages, press 31 to listen to saved messages.

Delete Message: Press 3 to delete a message.

Record Greeting: Log on, press 41, press 3 to choose which greeting to update and follow the prompts.

Record Spoken Name: Log on, press 432 and follow the prompts.

Compose Message: Log on, press 2, record message, press #, enter recipient mailbox number, press # twice to send message.

Forward Message: Log on, listen to message, press 5, record introduction, press #, enter recipient’s mailbox number, and press #twice to send.

Reply to Message: Log on, listen to message, press 4, record your reply and press # twice.

Call Sender: Log on, listen to message, press 44.

Select Full or Brief Messages: Log on, press 423 and follow prompts.

Switch to Voice Commands: Log on, press 9 and follow prompts.

Change Password: Log on, press 431 and follow the prompts.

Express Message: Dial x4444 from any campus phone or dial (336) 758-4444 from off campus, after the hearing the greeting enter the 4-digit extension followed by “#2” to leave your message.

Article Attachments

Was this article helpful?

Need Help?

Contact our Service Desk, conveniently located in the ZSR Library.